Home → Warehouse Equipment & Installations → Industrial Flooring → Surfacing & Coating

Duroflow

Duroflow
  • Brand: Durocem
Cement-based, quick setting self-levelling floor with high mechanical resistance.
Click here to request information and/or a quote

Detailed information about the product Duroflow


DUROFLOW is an innovative, self-levelling, cement based product developed by DUROCEM offering very high levels of abrasion and load resistance with extremely short setting times and without any risk of shrinkage. DUROFLOW can be pump-applied and is formulated according to a recipe based on special cements, very fine sands and chemical binders. Thanks to this product, finished industrial flooring can be produced in a single job, without joints, without shrinkage, to obtain a paving that is resistant to chemicals without requiring further treatment.

Fields of application
DUROFLOW is a specific product for either new or restored flooring. It is highly recommended when a perfectly level surface and optimum resistance to wear are required and time is very limited for the laying on-site, without the cost of machine- or plant downtime, and without the need to move any existing machinery or equipment already in operation: vertical storage systems, laser or wire-guided trolley systems, intensive-duty warehouses, workshops etc.

Features

  • Level of finish: similar to smooth flooring
  • Can be painted with a non film-former after 24 hours
  • Good resistance to chemicals (protection with appropriate products is recommended in case of prolonged exposure)
  • Ready for treading: 3 - 5 hours
  • Ready for vehicle use: 24 hours
  • Fully set: 7 days
  • Standing time after mixing: 3 - 5 minutes
(The above drying times refer to a 10 mm layer and may vary depending on the temperature, the relative humidity and the humidity contained in the foundation). The material's water content is 20% after hardening for 28 days at +23°C and with 50% relative humidity.

Technical specifications

  • Elasticity: 10 Mpas;
  • Resistance to compression: >35 Mpas
  • Grip (SS 92 35 07): 3 Mpas;
  • Shrinkage: 0.085%;
  • Fluidity (SS 92 35 19): 155-160 mm;
  • pH: approx. 11;
  • Dry product density: 1600 kg/m_;
  • Wet product density: 1900 kg/m_;


Method of use
DUROFLOW can be applied in thicknesses between 4 and 30 mm

Packaging
DUROFLOW is supplied in plastic-lined, 25 Kg paper sacks.

Storage
Can be stored for minimum 6 months in a dry place.

Warning
When fully dry, DUROFLOW can be moistened without any risk of damage. However, its strength may be significantly reduced in conditions of prolonged submersion; normal strength will be restored after 24 hours. Expansion joints and cracks, which continue to move, require maintenance.
Clean all tools in water immediately after use. This product contains cement, which could cause irritation. Avoid all contact with the eyes and prolonged contact with the skin.

Click here to request information and/or a quote